Free 2022 NSE 7 Network Security Architect NSE7_SDW-6.4 dumps are available on Google Drive shared by ActualTestsIT
Welcome to download the newest ActualTestsIT NSE7_SDW-6.4 PDF dumps: https://2cram.actualtestsit.com/Fortinet/NSE7_SDW-6.4-exam-prep-dumps.html ( 37 Q&As)
Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
NEW QUESTION 15
Which statement is correct about the SD-WAN and ADVPN?
- A. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
- B. ADVPN interface can be a member of SD-WAN interface.
- C. Dynamic VPN is not supported as an SD-Wan interface.
- D. Spoke support dynamic VPN as a static interface.
Answer: B
NEW QUESTION 16
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?
- A. The application control profile must be enabled on the firewall policy.
- B. The URL category must be specified on the traffic shaping policy
- C. The shaper mode must be applied per-IP shaper on the traffic shaping policy
- D. The web filter profile must be enabled on the firewall policy
Answer: D
NEW QUESTION 17
Refer to the exhibit.
Which two statements about the debug output are correct? (Choose two )
- A. FortiGate provides statistics and reading based on historical traffic logs.
- B. The debug output shows per-IP shaper values and real-time readings.
- C. This traffic shaper drops traffic that exceeds the set limits.
- D. Traffic being controlled by the traffic shaper is under 1 Kbps.
Answer: B,C
NEW QUESTION 18
Refer to exhibits.
Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)
- A. The implicit rule overrides all other rules because parameters widely cover sources and destinations.
- B. SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom.
- C. The initial session of an application goes through a learning phase in order to apply the correct rule.
- D. The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces.
Answer: A,B
NEW QUESTION 19
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)
- A. The zero-touch provisioning process has completed internally, behind FortiGate.
- B. The FortiGate cloud key has not been added to the FortiGate cloud portal.
- C. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
- D. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
- E. A factory reset performed on FortiGate.
Answer: A,B
NEW QUESTION 20
Which statement reflects how BGP tags work with SD-WAN rules?
- A. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- B. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- C. BGP tags match the SD-WAN rule based on the order that these rules were installed.
- D. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
Answer: A
NEW QUESTION 21
Refer to exhibits.
Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)
- A. All the existing sessions will continue to use port2, and new sessions will use port1.
- B. All the existing sessions will be blocked from using port1 and port2.
- C. All the existing sessions that do not use SNAT will be flushed and routed through port1.
- D. All the existing sessions using SNAT will be flushed and routed through port1.
Answer: A,D
NEW QUESTION 22
Which statement about using BGP routes in SD-WAN is true?
- A. Dynamic routing protocols can be used only with non-encrypted traffic
- B. VPN topologies must be form using only BGP dynamic routing with SD-WAN
- C. Learned routes can be used as dynamic destinations in SD-WAN rules
- D. Adding static routes must be enabled on all ADVPN interfaces.
Answer: B
NEW QUESTION 23
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Specify a unique peer ID for each dial-up VPN interface.
- B. Use different proposals are used between the interfaces.
- C. Configure the IKE mode to be aggressive mode.
- D. Use unique Diffie Hellman groups on each VPN interface.
Answer: B,D
NEW QUESTION 24
Refer to exhibits.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?
- A. The guaranteed-10mbps option must be selected as the per-IP shaper option
- B. The guaranteed-10mbps option must be selected as the reverse shaper option.
- C. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
- D. The reverse shaper option must be enabled and a traffic shaper must be selected
Answer: B
NEW QUESTION 25
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. The 10 Mbps bandwidth is shared equally among the IP addresses.
- B. A single user uses the allocated bandwidth divided by total number of users.
- C. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- D. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
Answer: D
NEW QUESTION 26
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. SD-WAN interface becomes disabled and port1 becomes the WAN interface
- B. Port2 might become alive when a single response is received from an SLA server
- C. Dead members require manual administrator access to bring them back alive
- D. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
Answer: D
NEW QUESTION 27
Which diagnostic command can you use to show the SD-WAN rules interface information and state?
- A. diagnose sys virtual-wan-link neighbor.
- B. diagnose sys virtual-wan-link member.
- C. diagnose sys virtual-wan-link service
- D. diagnose sys virtual-wan-link route-tag-list
Answer: A
NEW QUESTION 28
Which statement reflects how BGP tags work with SD-WAN rules?
- A. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- B. BGP tags match the SD-WAN rule based on the order that these rules were installed.
- C. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- D. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
Answer: B
NEW QUESTION 29
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. ADVPN should only be enabled on unmanaged FortiGate devices.
- B. Each VPN device has a unique pre-shared key configured separately on phase one
- C. The protected subnets should be set to address object to all (0.0 .0. o/o).
- D. On the hub VPN, only the device needs additional phase one sett
Answer: B
NEW QUESTION 30
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. ADVPN should only be enabled on unmanaged FortiGate devices.
- B. The protected subnets should be set to address object to all (0.0.0.0/0).
- C. Each VPN device has a unique pre-shared key configured separately on phase one.
- D. On the hub VPN, only the device needs additional phase one settings.
Answer: C
Explanation:
Explanation/Reference:
NEW QUESTION 31
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Specify incoming interfaces in SD-WAN rules.
- B. Specify outgoing interface routing cost.
- C. Select SD-WAN balancing strategy.
- D. Configure SD-WAN rules interface preference.
Answer: B,D
NEW QUESTION 32
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
- A. Port1 became dead 1ecause no traffic was offload through the egress of port1.
- B. Both SD-WAN member interfaces have used separate SLA targets.
- C. SD-WAN member interfaces are affected by the SLA state of the inactive interface
- D. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
Answer: D
NEW QUESTION 33
Refer to the exhibit.
Which statement about the trace evaluation by FomGate is true?
- A. The packet exceeded the configured bandwidth and was dropped based on the priority configuration.
- B. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
- C. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
- D. Packets exceeding the configured concurrent connection limit are dropped based on the priority configuration.
Answer: C
NEW QUESTION 34
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. VPN static routes are prevented from populating the FortiGate routing table.
- B. 100.64.3.1 is one of the remote IP address that comes through index interface 1.
- C. FortiGate created a single IPsec virtual interface that is shared by all clients.
- D. There are separate virtual interfaces for each dial-up client.
Answer: B,C
NEW QUESTION 35
Which statement is correct about the SD-WAN and ADVPN?
- A. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
- B. ADVPN interface can be a member of SD-WAN interface.
- C. Dynamic VPN is not supported as an SD-Wan interface.
- D. Spoke support dynamic VPN as a static interface.
Answer: C
NEW QUESTION 36
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
- B. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
- C. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- D. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
Answer: A,B
NEW QUESTION 37
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?
- A. Choose the suitable interface based on the interface cost and weight
- B. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule
- C. Configure an SD-WAN rule to load balance all traffic without VoIP
- D. Place the troublesome link at the top of the interface preference list.
- E. Use the performance SLA targets to detect latency and jitter instantly.
Answer: A,E
NEW QUESTION 38
Which statement about using BGP routes in SD-WAN is true?
- A. Dynamic routing protocols can be used only with non-encrypted traffic.
- B. VPN topologies must be form using only BGP dynamic routing with SD-WAN.
- C. Adding static routes must be enabled on all ADVPN interfaces.
- D. Learned routes can be used as dynamic destinations in SD-WAN rules.
Answer: D
Explanation:
Explanation/Reference:
https://www.fortinetguru.com/2019/09/using-bgp-tags-with-sd-wan-rules-fortios-6-2/#:~:text=SD%2DWAN%
20rules%20can%20use,to%20the%20customer's%20data%20center.
NEW QUESTION 39
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. The 10 Mbps bandwidth is shared equally among the IP addresses.
- B. A single user uses the allocated bandwidth divided by total number of users.
- C. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- D. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
Answer: D
Explanation:
Reference:
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/885253/per-ip-traffic-shaper
NEW QUESTION 40
......
Tested Material Used To NSE7_SDW-6.4: https://2cram.actualtestsit.com/Fortinet/NSE7_SDW-6.4-exam-prep-dumps.html